1
The OKMO  N01 engine model is now available for pre-order! 🥳🥳🥳🥳🤩🤩🤩. First-time pre-orders will save up to $100 USD. (Remember to use the promo code: N01)  All orders will ship on September 15 and will be marked with JIN's signature number, as production and testing take time. Thank you again for your understanding. For any questions, please email service@okmomodel.com.

OKMO

M90 Upgrade Hit & Miss Gas Engine Full Metal IC Engine

reviews
$339.99$349.99 piece
 Tax-Free on All Orders! | Easy Returns | Secure Payment | Free Shipping
20items available
Contact Us
Description

Upgrade Hit & Miss Gas Engine Full Metal IC Engine 


A hit-and-miss engine is a type of four-stroke internal combustion engine that is controlled by a governor to operate at a set speed.

This is a upgraded hit and miss engine. Equipped with wooden base, easy placement and operation.


Description:

Item Name: Hit & Miss Gas Engine

Color: Sliver

Material: Aluminium Alloy

Weight: About 2.2kg(Engine+Wooden Base)

Size Of Engine: 180*125*75mm(L*W*H)

Size Of Wooden Base: 180*66*50mm(L*W*H)

Cylinder Diameter: 22mm

Ltinerary: 20mm

Voltage: 4.5V

Fuel: Kerosene or Gasoline

The best tappet clearance: 0.5mm

Weight: 1610g

Revolutions Per minute:1200rmp


Engine Startup Steps:

1. Open the bottom of base to check the wiring of the engine, connect the fuel tank piep, and install 3 AA batteries.

2.Fill the fuel tank with gasoline(95#). When the filling is completed, make sure there's no air in the oil pipe.

3.On the right side of the engine(installation of the flying hammer position), slowly turn counterclockwise by hand to buy more than one turn.Its role can make the mixed gasoline fully enter the cylinder.

4.Turn on the power switch and turn the flywheel to start the engine counterclockwise on the right side of the engine(installing the flying hammer position)


Precautions:

1.If the ignition device is normal and the cylinder is under normal compression, if the machine still does not start normally, it's very likely that the carburetor needle should be adjusted.

2.Screw the screw on the top of the carburetor, then loosen 1/4 turn, start the flywheel. This can be done several times to make the mixing ratio gasoline and air reach the normal working mix ratio.


Note:

1.Due to the different display and different light, the picture may not reflect the actual color of the item. Thanks for your understanding.

2.Please allow little differs due to manual measurement.

3.Kids should be accompanied by adult.

4.Please be careful when you add the fuel.

5.An O-ring, which is not so airtight and can be started better


Package Included:

1 X Hit & Miss Gas Engine (With Base)

Recent Reviews
+